Greenheck Microprocessor Controller (475595 IOM) TAP v2.10 A Manual de usuario descargar pdf (Pagina 27)

THE PROBE ADJUSTMENT MENU ALLOWS THE USER TO CALIBRATE SENSOR PROBES

WITH AN OFFSET VALUE.

Similar screens are available for remaining sensor probes.

Analog Input

Outside Temperature

Offset: 0.0°F

Value: 70.5°F

THIS SCREEN ALLOWS THE USER TO CHANGE THE SERVICE LEVEL PASSWORD (PW1)

User Default

Insert new service password

(PW1): 1000

THIS SCREEN ALLOWS THE USER TO LOCK THE PROGRAM MENU.

Locking the program menu will prohibit users from changing any parameters.

Only menus normally accessed by pressing

Prg

will be locked. Users will still be

able to view unit status, alarms and temperatures.

Program Menu Lock

Lock program menus using

service password? (PW1): No

THIS SCREEN ALLOWS THE USER TO SAVE AND RESTORE THE DEFAULT

PARAMETERS STORED IN MEMORY.

If the user would like to save their settings, move the cursor to the SAVE position

and change to YES. This will save all of the current parameters into memory as

Service Settings. If the user would like to restore to these values at some point

in the future, moving the cursor to the RESTORE position, and selecting YES will

restore the controller to the user saved defaults.

User Default Settings

Save? No

Restore? No

THIS SCREEN ALLOWS THE USER TO VIEW UNIT RUN HOURS, AND ALTER SET POINTS

FOR MAINTENANCE.

Run hours: The amount of time in hours that the unit has been powered.

Set Point: The amount of running time in hours before a maintenance alarm

should occur.

Reset to Zero: Reset the measured amount of run time.

MAINTENANCE HOURS

SYSTEM

Run hours: 0000h

Set Point: 0000h

Reset to Zero? No

The Service Settings menu allows the user to change the default Service

Password (1000), save and restore default parameters, and adjust probe values.

G. Service

d. Service Settings

a. Working hour set

b. Probe adjustment

c. Password/Defaults

BACnet Read/Write

Function: Read

Update? Yes

*Cycle unit power to confirm

write command.

Current BACnet IP parameters should now be displayed in the BACnet TCP/IP

SETUP screen. If all values appear to be zeros, consult the factory. (Make sure you

have allowed several minutes for the controller to initialize).

*Values may appear to be zero prior to setting the Function to READ.

To change BACnet TCP/IP parameters:

1. Power on the controller and allow several minutes to initialize.

2. Go to BMS Config menu and view TCP/IP SETUP screen.

3. Move cursor to desired parameter by pressing the

buttons. Press

to select the parameter to change. Press the

buttons to adjust the

parameter. Press

to save adjusted value.

4. Once desired parameters have been entered, go to BACnet Read/Write

screen. Change Function to Write and Update? to YES.

5. Reboot the controller by cycling power to the unit. Allow several minutes for

the controller to initialize.

6. View TCP/IP parameters. If changed values did not save, contact the factory.

DDC Controller for Tempered Air Products

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Comentarios a estos manuales

Sin comentarios

Greenheck Microprocessor Controller (475595 IOM) TAP v2.10 A Manual de usuario Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Greenheck Microprocessor Controller (475595 IOM) TAP v2.10 A