Greenheck Microprocessor Controller v3.0 (469690) Manual de usuario descargar pdf (Pagina 22)

--Set Point Source--

Use local set point,

or BMS interface set

point?:Local

USERS CAN CHOOSE EITHER THE CONTROLLER OR THE BMS TO DETERMINE

SUPPLY DISCHARGE SET POINT DURING OPERATION.

This screen only appears if a BMS is wired into the controller.

Local means the controller set point will be used during operation, and BMS Interface

means that Supply Discharge set point can be inputted to the controller from the BMS.

Temperature Scale

Select:Fahrenheit

Display Buzzer

Select:Enable

THIS SCREEN ALLOWS THE USER TO ADJUST WHAT TEMPERATURE UNITS THE

CONTROLLER SHOULD OPERATE IN, AND WHETHER THE BUZZER SHOULD BE

ENABLED OR DISABLED.

The temperature can be either Fahrenheit or Celsius. The buzzer is only applicable

when there is a remote interface panel attached to the controller. If an alarm were to

occur, the remote display panel would begin buzzing loudly (if the buzzer was enabled)

and it would show the alarm status.

Select DDC configur-

ation code here.

Code:GYCA210X

THIS SCREEN DISPLAYS AND ALLOWS FOR ADJUSTMENTS TO BE MADE TO THE

CODE FOR THE UNIT.

This code is set from the factory to operate the components selected with the unit.

Refer to front page for code description. When troubleshooting, be sure to verify that

the code matches the components provided with the unit.

If the code needs to be modified, press Enter

and the cursor will move to the

first character. Use the

keys to adjust. Press Enter to move to the next

character. To finish, press Enter

until the cursor moves to the upper left corner of

the screen.

Change Passwords

LEVEL 1:0000

LEVEL 2:0000

THIS SCREEN DISPLAYS THE PASSWORDS WHICH PROTECT THE CONTROLLER FROM

TAMPERING.

Passwords must be greater than zero to be activated.

LEVEL 1 password locks out the following menus:

• SET POINTS • MANUAL OVERRIDES

• TIME CLOCK

LEVEL 2 password locks out the following menus:

• PROGRAM • I/O SETUP menus.

End of Program menu

PROGRAM MENU - continued

1 2 ... 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios

Greenheck Microprocessor Controller v3.0 (469690) Manual de usuario Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Greenheck Microprocessor Controller v3.0 (469690)